КСВ-метр Daiwa CN-801HP

Пассивный измеритель КСВ и мощности быстрого отсчета с двухстрелочной системой, предназначенный для измерения как прямой, так и отраженной мощности. Точность измерений ±10% от полной шкалы. Диапазон частот 1.8-200 МГц. Максимальная мощность 2000 Вт. Пассиввный измеритель мощности Daiwa CN-801HP позволяет измерять мощность P.E.P. в режиме однополосной модуляции.

Характеристики

Рабочая частота 1.8-200 МГц.
Измеритель КСВ и мощности быстрого отсчета с двухстрелочной системой.
Измерение как прямой, так и отраженной мощности.
Точность измерений ±10% от полной шкалы.
Максимальная мощность 2000 Вт.
Разъем: SO-239.

Индикатор подсветки шкалы.
Размеры: 159х109х122 мм.

 

Различия версий КСВ-метра

Из обзора QST март 2009

The CN-801 HP uses a large cross needle meter with pleasing pale blue meter lamps, making it stand out in any ham shack. Fairly heavy as wattmeters go, this giant size gray metal unit is ruggedly built and comes with removable rubber side bumpers, a useful feature that may prevent damage in the field.
Its range of 1.8 to 200 MHz is the widest in this group, with forward power scales of 20, 200 and 2000 W selected by the front panel RANGE switch. This activewattmeter must be connected to a dc supply for PEP measurements but will read average power and SWR with the power disconnected. I was surprised that it does not measure reflected power or display SWR in the PEP mode. Power accuracy is very good, though I did notice a jump up of a few watts when switching from AVG to PEP in the key-down CW test. The large 3.75 × 3.25 inch meter face is easy to read and provides good resolution with tick marks every 0.5 W up to 20 W (multiply by 10 or 100 for higher power ranges).
A rear panel receptacle accepts 13.8 V dc (power cord is included), and a meter lamp switch is located on the rear panel. I wished the case had more than its two rubber feet. The front feet are smooth plastic brackets that secure the front panel to the case — they prop up the front of the meter but provide no grip. Even with the meter’s weight, the front end slides a little when switching the RANGE or AVG/PEP toggle switches. A couple of stick-on feet will fix that. The 4 pages of instructions are in English on one side and Japanese on the other. There are plenty of illustrations and even some technical information on power measurement. The CN-801 HP is a good choice for home stations but a little large for mobile work. Note that there are several other instruments in the CN-801 family that cover different frequency ranges and power levels.

CN-801HP Модификация из QST October 2009 page 52.

CN-801HP калибровка

Калибровка необходима КСВ-метру только если произошла замена элементов на его схеме. Однако, если она действительно необходима, то на плате можно найти шесть подстроечных резисторов (рядом с операционным усилителем по направлению, противоположному подключению шлейфа проводов). Ими регулируют максимальные и минимальные значения мощности в положениях 20-200-2000 W. Для выполнения регулировок обязательно переключитесь в режим измерения AVG - усреднённое (не PEP - пиковое). Три резистора регулируют прямую и три отражённую. По номиналу они 10К-30К-50К для 20W-200W-2000 W соответственно. Нанесённые символы означают "F" (прямая мощность) и "R" (отраженная мощность). 
Очевидно, что Вам понадобиться иметь достаточно хороший эквивалент нагрузки, источника ВЧ-сигнала (передатчик, усилитель) и калиброванный ваттметр контроля показаний. Вместо ваттметра можно использовать калиброванный ВЧ-вольтметр:

  • 20W = 31.6Vrms (44.7Vpk),
  • 200 Вт = 100Vrms (141.4Vpk),
  • 2000 Вт = 316.2Vrms (447.1Vpk).

INSTRUCTION MANUAL

CN-801_series_manual.pdf
Adobe Acrobat Document 405.2 KB

Схема

CN-801HP Schematic.pdf
Adobe Acrobat Document 21.9 KB